MP91 Enable Sending of External Voltage/Mileage in V5 payload

mabbott

In the documentation there is an example of the V5 payload with both external voltage and mileage:
5 example (with mileage and external power voltage) *HQ,8168000008,V5,043602,A,2234.9273,N,11354.3980,E,000.06,000,100715,FBFFBB
FF,460,00,10342,4283,1000,125#

However the payload our device is sending does not include these last two values:
*HQ,7018509902,V5,213427,A,<redacted>,N,<redacted>,W,000.00,000,160525,FFFFFBFF,272,01,53201,64299079,10567978#

Is there a way we can switch this on with a server command?

Garin

@mabbott V5 is a custom firmware version. Could you please share your current firmware version via the SMS command “CXZT”? Then we can check if an OTA upgrade to support it is possible.

mabbott

Hi @Garin ,

the CXZT response is as follows:
*HQ,7018509902,SMS,GT08D(70SALASCD)_TQ_V_1.1 2024/06/07 ID:7018509902 IP:<redacted> 33033 UT:60,180,180 VOLT:12.6V APN:em GPS:C-24-18 GSM:15#

Garin

mabbott Unfortunately, after checking with our engineers again, the V5 is not compatible with the MP91. We’ve also updated the protocol to prevent any confusion for other customers.